Almost every siding problem on a Portland-area house comes back to water that stays in or behind the wall longer than the material can take. NOAA’s 1991-2020 normals give Portland International Airport about 37 inches of rain a year, most of it between November and January, so a small opening gets months of wetting every winter. The place you notice the damage is rarely where the water got in. Use this page to go from what you see, to the likely cause, to the repair that deals with it.
Symptom, cause and fix at a glance
| What you see | What usually causes it | What usually fixes it |
|---|---|---|
| Soft, crumbly boards, sills or corner trim | Wood kept wet behind failed caulk, under trim with no drip cap, or close to soil and decks | Cut out the decayed wood and stop the water: dry rot in siding |
| T1-11 panels peeling apart along the bottom | Water wicking into raw plywood edges and unflashed horizontal joints | New panels with Z-flashing, or a re-side if every wall shows it: T1-11 siding damage |
| Lap boards swollen and flared at the lower edge | Hardboard or OSB lap soaking up water where the paint no longer seals it | Usually replacement: hardboard siding failure |
| Stains or a soft patch below a roof corner or window | Missing kickout flashing, unflashed windows, torn or reverse-lapped wrap | Open the wall at the source and rebuild the flashing: water behind siding |
| Vinyl rippled, bowed or melted | Panels nailed too tight to move, or sun reflected off nearby windows | Rehang or replace the panels: vinyl siding |
| Boards cracked or knocked loose after a storm | Falling limbs and ice | Close the wall, then match and replace boards: siding repair |
| Paint peeling off the same boards every time | Moisture pushing out from a wet wall, or bare end grain underneath | Find the moisture first, then prime and paint: cedar siding |
Before you call: a ten-minute look
A screwdriver and a flashlight tell you more than a photo. Press the tip into the bottom course of siding, the lower ends of corner boards and the corners of window sills; sound wood resists, decayed wood lets it sink. Then look up before looking down. Find every place a lower roof meets a wall and follow the siding straight below it, because that is where water from a missing kickout shows up. Note which walls are affected: one wall usually means one water source, while the same failure on every wall usually means the product itself. On a house built before 1978, do not scrape or sand the paint to look underneath; that is lead-safe work. The siding inspection checklist walks the whole house in order.
Soft wood: how far has the rot gone?
Dry rot is fungal decay in wood that stays wet, so it starts where water sits: trim tops without a drip cap, board ends, the bottom course and sills. A few soft boards are a routine siding repair; what sets the price is whether the decay has reached the sheathing or framing. The dry rot guide for Portland homes covers ten places it starts and what it means when a house is sold.
Edges that swell or peel: which product is it?
T1-11 is grooved plywood that fails at its raw bottom edge and horizontal seams. On many houses and garages it was nailed straight to the studs and doubles as the wall’s sheathing, which changes the repair; the T1-11 page explains how to tell. Hardboard (often sold as Masonite) and LP Inner-Seal OSB lap swell once the paint stops sealing an edge or nail hole, and the swelling does not reverse. Both were installed widely in the 1980s and 1990s, and both class-action settlements have closed.
Water behind the wall, heat, paint and storms
A stain with no damage on the face means water is behind the siding, usually entering above and to one side, so the fix is to open the wall where it gets in rather than where it shows. Vinyl that ripples was usually nailed too tight to move; Portland reached 116°F on June 28, 2021. Paint that peels from the same boards is a moisture problem first, and the USDA Wood Handbook warns against painting wood wetter than 20 percent moisture. After a storm, such as February 2021’s ice storm, the largest outage in PGE’s history, close up any opened wall before the next rain and photograph it for an insurance claim.
Repair or replace?
Repair fits when the damage stays on one wall or a few boards, the sheathing behind is sound, and the siding can still be matched. Replacement is worth pricing when the same failure shows on several walls, the product is discontinued hardboard or T1-11, or the wall behind is soft in more than one place. The siding replacement page lists what a full re-side should include, and the cost page shows published price ranges with their sources.
Last updated