Most siding jobs around Beaverton start with a question that has nothing to do with siding: is the house inside the city? The Beaverton ZIP codes on this site (97003, 97005, 97006, 97007, 97008 and 97078, plus 97225 and 97229) take in the City of Beaverton and a ring of unincorporated neighborhoods that carry Beaverton or Portland mailing addresses but are run by Washington County. The two jurisdictions use the same state building code and different historic rules, and the unincorporated side holds some of the oldest houses in the area.
When you request a siding quote for one of these ZIP codes, note whether the house is inside Beaverton city limits or in unincorporated Washington County, because that decides which historic rules apply to the siding.
City limits or unincorporated Washington County
The Census Bureau lists Aloha, Bethany, Cedar Hills, Cedar Mill, Raleigh Hills, Rockcreek and West Slope as census-designated places, not incorporated cities. Addresses there are Washington County’s for permits and land use. Washington County’s Building Services FAQ says its answers apply only to unincorporated locations and points owners of property inside a city to that city.
Inside the limits, the City of Beaverton’s Building Division issues permits. Its adopted-codes sheet (revised February 2026) says the City adopts the state building codes without local amendments, including the 2023 Oregon Residential Specialty Code. For siding, that means the same answer on both sides of the line:
- No permit for siding alone. The state’s list of residential work that needs no permit includes repairing or replacing siding not required to be fire-resistant. The same page warns that local land-use rules come first, which is where landmarks and the County overlay come in.
- Walls close to a lot line. Under the state code, an exterior wall less than 3 feet from a property line must be fire-resistance rated, so re-siding one is permit work. Measure side walls on narrow lots and zero-lot-line townhouses.
- Sheathing and framing. Neither the City’s sheet nor the state list addresses rotten sheathing found behind old siding. Ask the building division with jurisdiction before it is cut out and replaced.
- Windows done at the same time. The state list exempts door and window replacement only where nothing structural changes, so widening an opening needs a permit.
Housing by decade, inside and outside the city
The median home in the City of Beaverton was built in 1987, and the 1970s are its largest single building decade (Census ACS 2020-2024):
| Built | Share of City of Beaverton homes |
|---|---|
| 1939 or earlier | about 2% |
| 1940-1969 | about 16% |
| 1970-1979 | about 20% |
| 1980-1989 | about 18% |
| 1990-1999 | about 16% |
| 2000 or later | about 29% |
About 53 percent of the city’s homes date from 1970 to 1999. The unincorporated places around it split into two groups: an older inner ring to the east and newer development to the north and west.
| Census place (unincorporated) | Median year built | Built before 1960 |
|---|---|---|
| West Slope | 1962 | 47.4% |
| Cedar Hills | 1965 | 33.6% |
| Raleigh Hills | 1967 | 28.8% |
| Rockcreek | 1977 | 2.3% |
| Aloha | 1984 | 7.5% |
| Cedar Mill | 1992 | 6.1% |
| Bethany | 2004 | 1.7% |
| City of Beaverton, for comparison | 1987 | 7.6% |
West Slope, Cedar Hills and Raleigh Hills, between the city and Portland’s west hills, are mostly postwar houses: in West Slope about one home in five was built before 1950. Rockcreek is the most 1970s-heavy of the group, at about 45 percent of its homes. Bethany is largely a 1990s-and-later suburb.
What goes wrong on Beaverton-area siding, by age
No survey records what siding is on Beaverton’s houses, so the age of the house is a guide to what to look for, not an answer.
- Postwar houses in West Slope, Cedar Hills and Raleigh Hills. Most were built before 1978, so any painted original wood needs the lead check below. Where the original lap or shingle survives, price siding repair of the rotted boards, or historic wood siding repair where the house merits it, before stripping sound wood. Rot concentrates at sills, trim and the bottom courses; the dry rot page covers where to probe.
- 1980s and 1990s houses across the city, Aloha and Cedar Mill. Two class actions set the dates to know. The Masonite settlement covered hardboard siding installed from 1980 to January 1998, and LP’s Inner-Seal settlement covered OSB lap installed before 1996; both have closed, so a failing board is now the owner’s cost. Hardboard and OSB swell at the bottom edge and around nail heads (hardboard siding failure). T1-11 plywood panels, found on houses and outbuildings of many ages, delaminate from the bottom cut and horizontal seams (T1-11 damage).
- 1970s houses, a fifth of the city’s stock and nearly half of Rockcreek’s. These predate both settlement windows, and after fifty years the siding on the wall may not be the original, so have it identified before choosing between repair and replacement. The lead question below applies to any built before 1978.
- 2000s and later houses in Bethany, Cedar Mill and the newer parts of the city. With younger cladding, look at the flashing first: stains below roof-to-wall corners and windows point to water behind the siding. The siding lifespan guide covers what the major manufacturers’ warranties do and do not include.
Where one product has failed on every wall, full replacement with new wrap and flashing is usually priced against repair, with fiber cement, engineered wood and vinyl as the new-cladding options to compare.
Beaverton’s landmarks
Beaverton regulates individual historic landmarks through Development Code Section 40.35. The City’s historic landmarks map, published with Volume III of its Comprehensive Plan and last updated in 2005, numbers 41 sites, three of them marked demolished. More than 20 are houses, among them the Newton Hoover House on SW 5th Street, the Jennie C. Scidmore House on SW Lombard, several Cady family residences and the Augustus Fanno farmhouse. The rest include downtown commercial buildings along Broadway, Watson and Farmington, shown on the map’s separate detail sheet of the old downtown.
For a listed landmark:
- Review is triggered by changes to any aspect of the exterior appearance, exterior finish materials included. That is an Alteration of a Landmark application, a Type 3 procedure decided by the Planning Commission.
- The criteria ask that deteriorating features be repaired rather than replaced where possible, and that new material other than paint match what it replaces in composition, design, color and texture.
- No historic review is needed for exterior repair and maintenance that stays consistent with earlier approvals, or for a change of paint color.
In practice, re-siding a landmark in a different material means a hearing, while repairing the existing wood does not. The City’s planning division can confirm whether an address is on the list.
Historic resources outside the city
Unincorporated neighborhoods fall under Washington County’s Historic and Cultural Resource Overlay (Community Development Code Section 373). The County applies it to buildings in its Cultural Resources Inventory, and it covers only the buildings the inventory describes as significant, important or contributing, not everything on the tax lot. Changes to the exterior design, material or appearance of a designated resource, siding by name, go through a Type II review, and the review uses the Secretary of the Interior’s Standards for Rehabilitation as guidance. Ordinary maintenance and repair that changes none of those needs no review. Under ORS 197.772(3), an owner can ask the County for an exemption from the overlay’s requirements through a Type I procedure; the designation itself stays on the map.
Lead paint on older Beaverton homes
About 38 percent of the City of Beaverton’s homes were built before 1980, and in West Slope, Cedar Hills and Raleigh Hills the share is far higher. The Census groups build years by decade, so whether a particular 1970s house predates 1978 needs checking against county records. On a pre-1978 home, disturbing 20 square feet or more of exterior paint requires a contractor with the Construction Contractors Board’s Lead-Based Paint Renovation license working lead-safe (Oregon Health Authority). Lead-safe setup and disposal belong in the quote.
What Beaverton siding work costs
Cost guides treat the Portland metro as one market and none breaks out Beaverton, Aloha or Cedar Mill. The most local figures are Angi’s Portland ranges, checked September 27, 2026: $903 to $2,835 for a single repair job, and $3 to $11 per square foot to patch fiber cement.
To see the scale of a re-side, take one side wall of a 1980s house, 40 feet long and 12.5 feet to the eaves: 500 square feet, or 5 squares. New fiber cement on that wall at Angi’s Portland installed range comes to $4,500 to $8,000, and stripping and hauling away the old hardboard adds $350 to $1,000 at HomeGuide’s national rate. That is an illustration, not a quote: trim, flashing, sheathing repair and lead-safe handling all sit outside it. Engineered wood ($7 to $12 a square foot installed, HomeGuide) and vinyl ($3 to $12 a square foot, Fixr) have only national ranges. The siding cost page lists every figure with its source.
Before you ask for a Beaverton siding quote
Have these answers ready and a contractor can price the job on the first visit:
- Whether the address is inside the City of Beaverton or in unincorporated Washington County.
- Whether the house is a City landmark or in the County’s cultural resources inventory.
- Which walls, if any, stand within about 3 feet of a property line.
- The year the house was built, for the lead question.
- What the siding is, if you know, and which walls show damage.
- For attached housing, whether the association or the owner is responsible for exterior walls.
The quote comparison guide covers license checks and what an Oregon siding contract should state. Nearby: Hillsboro, Tigard and Portland.
Last updated