A Siding Inspection Checklist for Portland Homes
A wall-by-wall siding check to do before the November rains: clearances, caulk, kickouts, paint, soft spots and woodpecker holes, and what to leave to a pro.
Published September 27, 2026Updated October 4, 2026
Most siding damage in the Portland area starts small and out of sight: a cracked bead of caulk, a missing flashing at a roof corner, a shrub holding a wall wet all winter. Each one is cheap to fix while it is small. A walk around the house once or twice a year finds most of them.
The best time to do it is late summer. NOAA’s 1991-2020 normals give Portland International Airport about half an inch of rain in each of July and August, against more than five inches a month from November through January. Whatever you find in August can still be caulked and painted on dry wood; whatever you find in December waits for spring while the water keeps getting in. A second walk in spring shows what the winter did.
Bring a flashlight, a flat screwdriver, binoculars for the upper walls, and your phone to photograph anything you want a contractor to see. Stay on the ground.
1. The bottom of every wall
The lowest course of siding takes the most water: rain splashing off the ground, sprinklers, snow and soil piled against it.
- Clearance to the ground. James Hardie’s care guide for fiber cement calls for keeping the required ground clearance, typically 6 inches, and says not to build landscaping up to the siding. Its current installation instructions call for at least 1 inch above roofing, and set their own minimum gaps where siding meets decks, paths, steps and driveways. Wood siding sitting in soil or bark mulch wicks water up its cut ends whatever the brand.
- Sprinklers. Adjust any head that soaks the wall.
- Plants. Hardie’s guide says to keep shrubs, bushes and small trees trimmed back from the siding. A wall behind a laurel hedge may never dry between November and April.
- Soft spots. Press the screwdriver into the bottom edge of a few boards and trim pieces on each wall. Sound wood resists; rotted wood lets the tip sink in. See dry rot in siding if it sinks.
- Swollen edges. Lower edges that have puffed up, split or flaked are the signature of failing hardboard siding. Layers separating at the bottom of vertical panels point to T1-11 damage.
- Below the siding. The soil and roof water that keep the bottom boards wet also reach the foundation. If the house sits over a crawlspace, Portland Crawlspace Pros’ seasonal checklist covers the grade and downspout checks from the foundation side.
2. Windows, doors and anything through the wall
- Caulk. Look at the joints where siding meets window and door trim, corner boards, and anything that passes through the wall: vents, hose bibs, light fixtures, cable and gas lines. Hardie’s guide says to re-apply caulking when it starts to show wear, using a sealant that stays permanently flexible. InterNACHI’s life expectancy chart gives caulking 5 to 10 years.
- Don’t caulk the laps. The horizontal overlaps of lap siding are meant to stay open so water that gets behind can drain. The Wood Handbook says not to seal them, and warns that failed sealant often traps water.
- Stains below corners. Streaks or soft siding below the bottom corners of a window usually mean water is getting in at the window, not through the siding. That is a job for a contractor; see water behind siding.
3. Roof edges and gutters
- Kickout flashing. Find every spot where a lower roof butts into a wall. There should be a small angled flashing at the bottom that throws roof water into the gutter. The Department of Energy’s Building America Solution Center describes it as directing water flowing down the roof into a gutter, and model codes require it. No kickout, plus stains or soft siding below that corner, is one of the most common causes of hidden rot.
- Gutters. The same source notes that in big storms rainwater can overflow the gutter and stream down the walls. Clear gutters and downspouts before the rains, and check that downspouts discharge away from the foundation, not against the siding.
- Gutter ends. Hardie’s installation guide calls for a 1-inch clearance between siding and the gutter end-cap.
4. The paint or stain
Paint is the siding’s first defense, and it wears out long before the siding does. Look for:
- peeling or blistering, especially on south and west walls;
- bare wood showing at board ends and bottom edges;
- chalky paint that leaves a heavy residue on your hand;
- paint that peels again within a year or two of the last paint job, which usually means moisture is coming from behind.
The Wood Handbook’s advice is to inspect the wood for decay whenever you repaint. How long each finish lasts is covered in how long siding lasts in Portland.
5. Green film, black spots and moss
North walls and walls under trees grow algae, mildew and moss in Portland’s wet months. To tell mildew from dirt, the Wood Handbook’s test is a drop or two of household bleach on the spot: mildew bleaches out, while dirt and iron stains do not. Never mix bleach with ammonia.
Clean gently and to the siding maker’s rules:
- Fiber cement. Hardie suggests washing down with a garden hose every 6 to 12 months. A pressure washer is allowed only with a wide fan nozzle, held 6 feet or more back from the wall, at under 1,500 psi. Acid and high-pressure washing can damage the surface.
- Vinyl. The vinyl industry’s cleaning guidance recommends a soft cloth or a soft-bristled brush, working from the bottom up, and never aiming a spray upward, which drives water behind the panels. For mildew it suggests 30 percent vinegar in water, and it lists undiluted chlorine bleach among products to avoid.
- Wood. Low pressure, with the stream pointed down.
Moss killers are a separate caution. Oregon State University’s moss guidance warns that zinc and copper products are harmful to fish and can run off into waterways, and to hold off if rain is forecast in the next 24 hours. Trimming back the trees that shade the wall does more over the long run.
6. Holes and drumming
A woodpecker hammering on the house is usually a northern flicker. The Oregon Department of Fish and Wildlife says the flicker is the most abundant woodpecker in Oregon, that it drums on wood siding, and that drumming can mean insects are living under the siding. Woodpeckers are protected under state law and the federal Migratory Bird Treaty Act, so the fix is to check the siding for insect damage and repair the holes, not to harm the bird. The U.S. Fish and Wildlife Service has advice on deterring them, and the guide to woodpecker holes in siding covers reading the holes, repairing them and netting the wall.
7. After an ice or wind storm
Walk the house again once it is safe. Look for cracked or holed boards where limbs fell, panels lifted or missing on the windward side, and dented gutters that now spill onto the wall. Photograph damage before anything is moved or repaired, in case you make an insurance claim for the siding.
Houses built before 1978
Houses this old often have lead in the lower layers of paint. The federal renovation rule does not apply to homeowners working on their own home, but the hazard is the same. Multnomah County’s lead-safe guidance covers how to scrape and paint safely if you do it yourself. If you hire the work out and it disturbs 20 square feet or more of exterior paint, the contractor needs an Oregon CCB lead-based paint renovation license.
What to leave to a contractor
Caulking, washing, trimming plants and pulling mulch back are homeowner jobs. These are not:
- rot deeper than the surface of a board, or rot that returns after a repair;
- stains, damp drywall or a musty smell on the inside of an exterior wall;
- missing kickout or window flashing, which means removing siding to fix properly;
- swelling or delamination on more than one wall;
- anything you would need to climb a ladder above the first floor to reach.
Most of those are a siding repair. When the same failure shows up on several walls, a siding replacement lets the wrap and flashing behind it be rebuilt at the same time.
If your walk turned up something you want looked at, request a siding quote and include what you found and on which walls; we’ll follow up about your project. The guide to comparing siding quotes covers what to check before you hire.
This page is general information, not professional advice about your specific situation. Have it assessed by a qualified professional before making decisions. Last reviewed October 4, 2026.
Start My Siding Quote
No cost and no obligation. Tell us about the house and the siding problem to get started.